How to Install a Vinyl Privacy Fence
Due to the fact vinyl fence systems use panels that lock into vicinity, putting in them is literally a snap.
Dig holes for posts the usage of post hollow digger
Mark the Fence area
As soon as you’ve got decided the property line and legal setback, mark out the vicinity of the fence. Mark the locations of the corner put up holes with spray paint. Mark the places of the final line posts, maintaining the distance between the posts lightly spaced at about 8’.
Briefly brace posts with 2 x 4 s
Temporarily Set the Posts
The use of a publish hollow digger, dig holes about 24″ deep and 10″ in diameter. upload some inches of gravel to the lowest of the holes for drainage. Insert nook posts in holes. make certain the posts are degree and plumb. temporarily brace posts with 2″ x four”s attached to put up tops and ground.
Run a String Line
Run a string line from the pinnacle edges of the nook posts. make certain the string is taut and level. This gives a guide to make certain that the posts are all set up at the equal peak. installation ultimate line posts checking that each is plumb and on the identical peak as the corner posts.
Snap ends of pinnacle and bottom rails into holes
Collect the Fence Panels
Vinyl fence panels are comprised of a bottom rail, top rail and slats. assemble them in keeping with manufacturer’s commands. Snap the ends of the top and backside rails into the ideal holes at the fence posts.
Permanently Set the Posts
Mix fast-drying cement in line with manufacturer’s directions and pour in holes. depart the 2″ x 4″ bracing in vicinity in a single day whilst the cement treatment plans. put off the bracing. follow percent cement to the inside of the post caps and then deploy atop posts.