Webcome to Zhejiang Jovyea Plastic Co.Ltd.

+86-18257261120 sales@bestpvcfence.com

How to install vinyl fence gate

The sight of a vinyl fence gate is turning into common. For people who are adventurous sufficient to construct their personal gate, here are 6 steps to get the task done. before you start, discuss with your county to determine your own home strains and the vicinity of any underground utilities. you can also want to gain a constructing permit.

Step 1: Plot the yard

Measure your backyard and plot where you want your fence. be sure to mark in which you need all your posts. region stakes where you want the corner and gate publish to be set.

Join the posts with string. vicinity stakes in which you need the supporting posts, and be sure they’re touching the string. This guarantees that the posts might be nicely aligned.

Step 2: Dig Postholes

Once every stake is in area, start to dig the postholes at every stake. each hollow need to be ten inches in diameter. ensure that the width is the equal at both the pinnacle and bottom of the hole. The intensity of each hollow is dependent on the type of publish and your region. If it freezes to your location, the submit ought to be under the frost line.

A chief put up, one on the nook or used as a gate guide, wishes to be approximately six inches in addition within the floor than the posts used as primary help. Take this under consideration whilst you buy posts, due to the fact you need them to align with each other whilst the fence is complete. an extra six inches is also needed for the gravel used to stabilize the cement.

Step 3: Set Posts

Place the give up and corner posts first. Fill the holes with six inches of gravel and then with concrete, following the manufacture’s instructions. faucet the posts into the concrete in order that it fills the hole middle. the use of a level, plumb and stage each put up. Slope the concrete overflow so that water will not be capable of pool. allow the concrete dry.

Step 4: attach Panels

Attach the brackets and panels in line with the manufacture’s instructions. Slide the panels into the brackets and screw the panels onto the posts.

Step 5: deploy Gate

The final step is to put in the gate. be sure the gateposts are eleven/4 inches wider than the gate to allow for hardware. Insert 2 with the aid of 4s into the hole vinyl. these will offer greater aid. make sure to degree the top of the two by using 4 with the vinyl. Pre-drill the holes for the hinges and latch. make sure that the bottom of the gate may be aligned with the bottom of the fence. Mount the hinge to the gate, then mount the gate to the post. eventually, attach the latch.

Step 6: attach accessories

If you plan on attaching accessories, now is the time to do it. practice vinyl adhesive to the pinnacle of the posts and firmly maintain the attachments to the posts for as a minimum ten seconds. make certain to wipe away any extra adhesive.







Email me

Mail to us