Webcome to Zhejiang Jovyea Plastic Co.Ltd.

+86-18257261120 sales@bestpvcfence.com

How to Put Up a Picket Fence

Fence construction commonly isn’t a complicated count number, but it may become a touch more so when the floor is sloped. you can tackle the trouble of sloped ground with special designs. In a parallel layout, the rails comply with the slope of the ground, however in a step design, they continue to be horizontal. whilst you operate the step technique, you often want taller posts — and extra of them — than if you use the parallel technique. The latter method is the better option for a picketen fence due to the fact you can level the pickets to make amends for the sloped rails.

1.Contact the application company before you start constructing your fence and reap a map of all the underground cables to your backyard. this will assist you avoid digging via a cable and possibly disrupting telephone carrier for the whole community.

2.Lay out the perimeter of the fence, making sure to keep it in your facet of the belongings line. To be on the secure side, hold it at the least one foot to your aspect. Mark the corners with stakes.

3.Stretch string between the corner stakes and pound greater stakes for the line posts with their faces touching the string. space them approximately eight feet apart.

4.Dig the hole for every publish with a submit hollow digger. The intensity of each hole need to be 1/3 of the peak of the put up that goes in it. in case your fence is five feet high, the hole must be 20 inches deep, and the posts themselves ought to be eighty inches long. Dig each hole a further 3 inches deeper and fill the bottom with three inches of pea gravel for drainage.

5.Set every post in concrete, leveling it with a degree as you add the concrete. let the concrete set for 24 to 48 hours.

6.Make a mark on every post for the location of the pinnacle rail and every other one for the lowest, the usage of a tape measure and a pencil. those marks need to be the equal distance from the ground on each put up. Make marks on every facet of each submit that faces every other submit.

7.Keep a chunk of two-through-four-inch lumber between a pair of adjoining posts with a helper and middle the ends at the pinnacle pair of marks. The lumber must be lengthy enough to overlap each put up. it is going to be a rail.

8.Trace a line along the edge of each publish on every edge of the rail with a pencil, then cut the rail along this line. you make this bevel reduce by using adjusting the angle of the circular noticed blade to fit the road and then creating a crosscut.

9.Assist the rail between the posts with a helper and screw it to the posts with 3-inch outdoors picketen screws. force the screws through the rims of the rail and into the posts. install all the other pinnacle and backside rails within the same way.

10.Set up the pickets by screwing them to the top and bottom rails with 1 1/2-inch outside timber screws. deploy the primary picketen at one side of the gate and work around the fence to the alternative side. Use a stage to maintain every picketen vertical, and preserve the tops of the pickets a uniform distance from the top rail.

PREV
NEXT

RELATED POSTS

Inquiry

Skype

WhatsApp

WangWang

QQ
Email me

Mail to us