Webcome to Zhejiang Jovyea Plastic Co.Ltd.

+86-18257261120 sales@bestpvcfence.com

how to update a Stockade Fence gate put up

Stockade Fence Gate

A stockade fence, additionally called a privacy fence, is held up with the aid of sturdy four-by using-four posts and built with tall upright panel-boards that have little to no gap among them. This kind of fence efficaciously prevents intrusion from the outdoor, making it tough to benefit get admission to or see in, and forestalls get away from the internal, that’s commonly for the protection of kids or pets. regardless of handled wooden, stockade fence posts do not remaining all the time, specifically if situations are extremely damp. frequently inspecting the bottom of every submit for water harm allows catch issues before they emerge as irreparable; but, in case you find a damaged submit, the only alternative is to replace it. because the posts are protected on one side by fence panels, a few prep work is required to benefit get entry to and eliminate it.

1.Pry out nails or use a drill to back out the timber screws attaching go beams to the post. The cross beams preserve the slats in area between the posts.

2.Circulate the loosened fence panels barely far from the put up. don’t pressure them too some distance or you may harm the other ends of the panels that are nevertheless connected to posts. in case you decide upon not to worry approximately this, eliminate the move beams from the posts on the other give up and set the panels apart.

3.Grip the put up you’re casting off and twist, push and pull on it to loosen it from the soil. If publish is held inside the floor with cement, dig a hole subsequent to the concrete to expose it, then wreck it up with a rock bar, additionally known as a San Angelo bar. Drop the bar down on the concrete to break it up.

4.Remove the submit and set it apart. If the publish is cussed, pry it out with the stop of the rock bar. finish breaking up the the rest of concrete, if it became used, and get rid of it from the hollow.

5.Scrape the loosened soil out of the bottom of the hole until you reach the gravel at its base. If there is no gravel inside the hole, eliminate 2 greater inches of soil and percent 2 inches of rocks at the lowest to keep water tired from the bottom of the post.

6.Insert a brand new post within the hollow of the identical length as the only eliminated. measure the peak of an adjoining submit from the ground to the top, and examine it to the new put up.

7.Alter the depth of the hollow if essential to make it in shape.

8.Tie one stop of three pieces of string across the submit 1/three of the manner down. Tie the alternative end of the strings to timber stakes.

9.Hammer the stakes within the floor, spacing them flippantly apart, preserving the strings tight. check the put up with a level as you visit keep it vertical to the floor on all aspects.

10.Blend cement in a bucket, following the package deal guidelines. Pour the cement inside the hollow up to the pinnacle of the hole. allow the cement to remedy for at the least 24 hours.

11.Reattach the cross panels to the brand new publish with four-inch wooden screws.







Email me

Mail to us